PRODUCT
INFORMATION
320





320

ORTHOTIC CHLOROPRENE SHOE ADHESIVE


320 is a sprayable contact cement especially formulated for use in fabricating orthotic insoles and for the manufacture and repair of shoes.
320 can be used on a variety of substrates including, polypropylene, SBR, PPR, EVA and cushion crepe.
  1. Excellent room temperature contactability
  2. Fast drying
  3. High heat resistance
  4. Can be used to replace mechanical fasteners
Composition 320 is made with a blend of flammable solvents, chloroprene rubber and high tack resins.
Color Opaque light tan
Viscosity 200 to 250 cps
Solids Content 16 - 18 %
Solvents Use our special "341 Solvent Blend" for best results to clean-up and thin. Toluene may also be used for clean-up.
Storability 6 months
Weight per Gallon 7.0 0.5 #/gallon
Application techniques Spray, brush or roll the adhesive on to both surfaces to be joined. Allow the adhesive to dry for 5 or 10 minutes. Properly position the two surfaces and press together. Repositioning the surfaces is usually not possible, so proper position when joining the surfaces is important. The open time is 20 to 30 minutes depending on temperature. May be reactivated with heat. Alternately, if one of the surfaces to be joined is porous and breathable, the adhesive may be applied to one surface, and the two surfaces may be brought together while the adhesive is still wet.
5 gallon pails or 55 gallon drums
NOT RECOMMENDED FOR OUTDOOR USE

Because we have no control over the manner in which this product may be used, we cannot guarantee the end results to be obtained in our customers' processes. Adhesives and Chemicals shall not be liable for any loss, damage, or injury, whether ordinary, direct, incidental, or consequential, arising from the purchase, possession, handling, use, or inability to use this material.
PRECISION ADHESIVES AND CHEMICALS
131 Brown St. Yatesville, PA 18640
Phone: 570-654-6735
Fax: 570-654-0676

Click here to return to PA&C homepage.